I added a special bracket to attach two Loc-lines to the quill, so that the stream follows the cutter if necessary. This assebmly can be removed. I now have a Loc-Line fixed to the head (for drilling mostly) and the loc-line attached to the quill (for milling). Both are on separate valves, so I can pick which one runs. The clamp does not interfere with homing. The bracket also has a slot to mount the mister line if necessary. I of course made this bracket on the mill (and could not easily do it on my manual mill due to its curvy shape where it "hugs" the quill). Also can be seen, my chip guard, the mounted monitor, and electrical cabinet. Also a Saitek joypad that I use for jogging the mill. Clearly a work in progress, but it is closer to finish now than it is to start and it works.