Up
Day 2 I spent finishing up the enclosure made of junk pieces of particle board, and everything related to wiring of the 3 phase output.
The output from the phase converter proper, goes into a heavy duty Square D disconnect rated for 30 amps. This disconnect is there so that I can mess with the phase converter without, at the same time, running the risk of accidentally powering attached machines.
From the disconnect, the three phases go into the terminal block inside a steel electrical box. The idea is to connect my 2 phase devices to that terminal.
I was able to test the phase converter by testing, at the same time, a 1.5 HP 180 VDC motor and 3 phase controller/rectifier for it. Everything worked.
